Description and Specification.

The Routout CNC 4 Axis Main-board allows you to connect up to 4 Routout drivers within

seconds with absolutely NO wiring. The inputs have opto-isolation and there is a Safety Charge Pump detection for use with software that supports it. I.E Mach 3 / Linux EMC

 

Features.

12 - 30V input for drivers.

5v supply can be either supplied via USB or external supply.

Opto-coupled inputs for home and emergency stop.

Main board can accommodate 1, 2, 3 or 4 Drivers.

Safety Charge Pump detect for Mach 3 and EMC ( disables drivers & provides an output

to disable external relay)

Printer port, Input port, Motor output connections on rear of PCB so just insert into an enclosure and your done (with no wiring)

Additional Hardware E-stop input

 

Absolute Maximum Ratings

Exceeding these ratings WILL destroy your Mainboard !

 

Input Voltage 30 Volts DC

 

Logic Input 5V

 

Timing Requirements

200nS Minimum Command active time before step pulse.

 

1.0uS Minimum command active time after step pulse.

1.0uS Minimum step Low time.

 

For a complete PDF Spec sheet Click on the link below. You will need Adobe Reader to read it.

Routout CNC PDF

If you require any further information then please do not hesitate to contact me on Tel: (01269) 844744 or email sales@routoutcnc.com

Price £ 70 + £4.25 P&P +Vat  to the UK Only