Back to look at more products

 
 
 

 

Routout CNC Dragon Controller.
         
 
RoutOut CNC Dragon Hardware.

Description and Specification.


Routout CNC Dragon Controller - 'Making CNC simple.'

The Routout CNC Dragon Processor is a three axis control board, and has many uses including for CNC retrofitting / robot control or driving you own CNC machine. It is simple to wire and is controlled via USB or RS232 serial connection. It is fully compatible with all step and direction motor drive cards including the Routout CNC Stepper Motor Drivers, and utilises the same FL command Set as the Routout CNC CAD CAM Software. The Dragon processor also has some extended commands.

Features

  • 3 X AUX Outputs -Darlington Transistor 1A Drive Capabilities.
  • 3 X Enable Outputs.
  • 3V to 5V logic inputs.
  • 3 X Home inputs X,Y & Z.
  • Limit Inputs.
  • PCB foot-print only 127mm X 120mm
  • USB or RS232 Serial Port
  • Emergency Stop Input.
  • Integral or External Reset circuitry.
  • Built in regulator.
  • Lowers the burden on you PC so you can drive it from slow old PC / Laptop
  • Stepper motor drive outputs via screw terminals or 25 way LPT connector (Male or Female can be supplied).
  • Windows 98 & XP compatible.
  • Very easy to setup and use.
  • Full technical support given.
  • Can be used to replace old DOS printer port driven Stepper Motor Controllers
  • Directly compatible with the Routout CNC LPT Software. - Upgrade and reap the rewards of a faster and slicker CNC experience.



Computer minimum Requirements :

Windows 98,XP
P1 - 500 Mhz or greater
1 spare USB or Serial Port.

For additional information please click on the link below and download the PDF Manual.

Dragon Processor PDF PDFLOGO

If you require any further information then please do not hesitate to contact us on Tel: (01269) 841230

Dedicated technical Help Line (0121) 2884066

 

Price £ 107.00 Including P&P to the UK Only